3. Tap any of the quick search buttons to get an
instant list of Places.
iGo map Operation
3.1.3.2 Searching by category
4. The Places in the list can be ordered by their
distance from the current or last known position, from
the destination, or by the length of the necessary
detour. If you need to reorder the list, tap .
To filter the list of results by providers, tap and
then the provider logo on the right side of the screen.
5. (optional) If needed, tap to further
filter the list of results.
6. Browse the list and tap one of the list items. A full
screen map appears with the selected point in the
middle. The name and address of the Place is
displayed at the top of the screen.
7. Tap to see the details of the selected Place,
or to save the location. If there is a telephone number
saved for this Place, you can make a call to that
number by tapping the green button at the bottom.
8. If necessary, tap the map somewhere else to
modify the destination. The cursor ( ) appears
at the new location.
9. Check the settings for road types and change them
if necessary.
1. Tap on the Navigation view to access the
Navigation menu.
2. Tap and .
3. Tap
4.Select the area around which you would like to
search for the Place by tapping .
By default, the search area is around the current
position (or if it is not available, around the last known
position). In this case, the following result list is
ordered by the distance from this position.
Tap to enable or avoid freeways, tap for
roads with Period Charge or Per-use Toll, tap for
ferries, or tap for carpool lanes.
10. Tap to confirm the destination.
You can also select a nearby point on the map
or tap to select a different destination.
11. The route is calculated and the map appears
showing the entire route, where you can check route
information and route alternatives. Tap to
modify the route parameters, or tap to
start your journey.
To search for Places by their categories and subcate-
gories, perform the following steps:
46
To Next Page
Loading...