Resi Server-Grade Decoder

To Next Page

Server-Grade Decoder - Setup Instructions

1. Connect your cables

○ It is recommended to connect power through an uninterruptible power supply (UPS).

■ Secure your network ethernet cable to the RJ-45 jack. Do not use an ethernet

cable with the clip removed; it should not easily pull out.

○ The SDI / HDMI ports found on the PCI cards are for production video and

professional audio output. Video and audio are output to both SDI & HDMI

simultaneously, one video channel per card. D2202 decoders do not include HDMI

output, but can accept reference-in. Audio should be de-embedded from SDI.

○ Use the DVI-D, HDMI, or DisplayPort on the PCI GPU (not the ports on the motherboard

I/O panel) to connect one 16x9 1080p computer monitor for decoder control.

○ Connect a wired keyboard and mouse. Wireless is not recommended.

2. Turn on the decoder by pressing the power button on the front of the unit.

3. Once the decoder has fully started, you will see the Server-Grade Decoder login page. By

default the decoder will use a DHCP (automatic) network connection. If you need to set a

static IP address, click the “IP Settings” button on the bottom-right hand corner of the screen

and conﬁgure the appropriate IP address.

Need help? E-mail us at support@resi.io, or call 800-875-0696, Option #2

Need help?

Do you have a question about the Resi Server-Grade Decoder and is the answer not in the manual?

Summary

Connect Cables and Peripherals

Network Ethernet Connection

Securely connect the network ethernet cable to the RJ-45 jack. Ensure the clip is intact.

Video and Audio Output

SDI/HDMI ports output video and audio; D2202 decoders lack HDMI output but accept reference.

Computer Monitor Connection

Use DVI-D, HDMI, or DisplayPort on the PCI GPU for a 16x9 1080p monitor.

Peripheral Connection

Connect a wired keyboard and mouse; wireless is not recommended for decoder control.

Power On and Initial Startup

Power On

Turn on the decoder by pressing the power button on the front of the unit.

Initial Network Configuration

Decoder uses DHCP by default; configure static IP via 'IP Settings' if needed.

System Login and Updates

Login Process

Software Updates

Check for and perform available updates via the user icon; restart may be required.

Configure Decoder Settings

Video Output Configuration

Set output device (1 card recommended) and video format to match encoding for best quality.

Timezone Setting

Configure the timezone according to the local time of the decoder.

Start Streaming Event

Event Selection and Buffering

Select an event from the Events tab and start streaming. Buffer 5 min (internet) or 2 min (LAN).