ResMed AirCurve10 ASV User Manual

Setup
CAUTION
Do not overfill the water tub as water may enter the device and air tubing.
1. Place the device on a stable level surface.
2. Plug the power connector into the rear of the device. Connect one end of the power cord into
the power supply unit and the other end into the power outlet.
3. Connect the air tubing firmly to the air outlet located on the rear of the device.
4. Open the water tub and fill it with distilled water up to the maximum water level mark.
Do not fill the water tub with hot water.
5. Close the water tub and insert it into the side of the device.
6. Connect the free end of the air tubing firmly onto the assembled mask.
See the mask user guide for detailed information.
Recommended masks are available on www.resmed.com.
4

ResMed AirCurve10 ASV Specifications

General

Pressure Range	4-25 cm H2O
Data Storage	SD Card
Sound Level	26 dBA
Dimensions	116 mm x 255 mm x 150 mm
Altitude Compensation	Automatic
Display	Color LCD
Device Type	Bi-Level Positive Airway Pressure (BiPAP) Device
Therapy Modes	ASV, CPAP, S
Humidification	Integrated Heated Humidifier
Ramp Time	0-45 minutes
Climate Control	Optional ClimateLineAir heated tube
Power Supply	100 – 240V AC, 50 – 60Hz, 2.0A