ResMed AirCurve10 ASV User Manual

Caring for your device
It is important that you regularly clean your AirCurve 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
Disassembling
1. Hold the water tub at the top and bottom, press it gently and pull it away from the device.
2. Open the water tub and discard any remaining water.
3. Hold the cuff of the air tubing and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
Cleaning
You should clean the device weekly as described. Refer to the mask user guide for detailed
instructions on cleaning your mask.
1. Wash the water tub and air tubing in warm water using mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the water tub and air tubing thoroughly and allow to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth.
8

ResMed AirCurve10 ASV Specifications

General

Pressure Range	4-25 cm H2O
Data Storage	SD Card
Sound Level	26 dBA
Dimensions	116 mm x 255 mm x 150 mm
Altitude Compensation	Automatic
Display	Color LCD
Device Type	Bi-Level Positive Airway Pressure (BiPAP) Device
Therapy Modes	ASV, CPAP, S
Humidification	Integrated Heated Humidifier
Ramp Time	0-45 minutes
Climate Control	Optional ClimateLineAir heated tube
Power Supply	100 – 240V AC, 50 – 60Hz, 2.0A