18
Screen display
To conserve battery life, the Remote Control 2 has a standby fea-
ture that automatically puts the Remote Control 2 into a “sleep”
mode after 20 seconds of non-use. Whenever the display is dark,
simply press any button on the keypad to awaken the display and
then perform the desired action.
Remote Control 2 performance
The Remote Control 2 performs best when buttons are pressed
one step at a time rather than in rapid sequence. When adjust-
ing volume, for example, briefly press a button and wait a short
moment for the beep tones* to be heard before continuing. This
tip applies to all button use but is especially relevant to volume
adjustments.
*Please note that tones may have been disabled by your hearing
care professional during fitting
To Next Page
Loading...
