SAFELY OPERATING YOUR
ALTEA 90/120 WORK BED
OPENING YOUR ALTEA 90/120 WORK WALL BED
1
2
3
4
Grasp either one of the legs to pull the
bed down.
Make sure to support the bed frame for
the entire descent until both legs are
resting on the floor.
NOTE: The Altea 90/120 Work will then be
safely locked in place in the open position.
Do not attempt to close the bed without
releasing the safety latch. If you lift the
leg too far in error, pull down on the safety
latch above the leg to release.
Release the two mattress straps by
squeezing the center of the clasp.
Tuck the straps under the mattress.
See you in the morning!
With a finger, pull out the bottom of one
of the legs located in the space between
the front panel and the structure of the
bed. Lift up the leg about 30 degrees to
release the safety latch.
Do not attempt to close the bed without
releasing the safety latch. See reverse for
instructions on releasing the safety latch.
27
To Next Page
Loading...
