Features
The Sensor can be fitted to doors, windows, and
any other object that opens and closes.
Transmits a signal to the Control Panel/Siren when
contact is broken.
Appearance & PCB Layout
2. DOOR/WINDOW SENSOR
LED
Transmitter Magnet
LED Indication
Flashes once: door/window opened, transmitter
sends signal to the Control Panel/Siren
Flashes rapidly: low battery indication, (immediate
battery change recommended)
AA
Tamper
Zone
4. Fit the Sensor in a position that will cover your
desired protection area:
a. Fix the bracket to the wall with the fixings kit
supplied. For optimum performance set the
the height of the bracket to 2 metres above
ground level.
b. Adjust angle of the PIR Sensor to cover the
required detection area.
PIR Installation continued…
5. To test, walk in front of the Sensor - the LED
should illuminate once when movement is
detected. If the Sensor is triggered twice in 3
minutes, it will enter into power saving (sleep
mode). If no movement is detected within the
next 3 minutes, the Sensor will return to normal
working mode.
Top view
Side
2m
Ground
Power Supply DC 3V (AA 1.5V LR6 Battery x 2)
Static Current
≤ 90uA
Alarm Current
≤ 9.5mA
Detection Area 8m/110°
Transmitting Distance ≤80m ﴾in open area﴿
Pet Immunity ≤ 25kg
Radio Frequency
433 MHz
Housing Material ABS Plastic
Operating Temperature -10°C~50°C
Relative Humidity
≤ 80% ﴾non‐condensing﴿
PIR Sensor Dimensions
(L x W x D)
108 x 52 x 36.8 mm
Bracket Dimensions
(L x W x D)
52 x 30 x 26.5 mm
Specification
To Next Page
Loading...