Response Electronics miGuard A1R - Remote Control; Features and Functions; Appearance and LED Indication

The Remote Control enables you to quickly and
conveniently Arm and Disarm your Alarm System.
In the event of an emergency when in or near your
property, pressing the SOS button will trigger an
alarm condition on the Control Panel/Siren.
Features
LED Indication
Flashes once: transmits the signal
Low Light Level: low battery indication, (immediate
battery change recommended)
Specification
Buttons/Functions
See over.
Installation
Specification
Power Supply DC3V CR2025 Lithium Battery
Transmitting Distance ≤80m ﴾in open area﴿
Radio Frequency
433 MHz
Housing Material
ABS Plastic
Operating Temperature -10°C~50°C
Relative Humidity
≤ 80% ﴾non‐condensing﴿
Dimensions (L x W x D)
58 x 31 x 9.5mm
-10°C~55°C
DC 1.5V (AA 1.5V LR6 Battery x 1pc)
433MHz
≤ 30uA
≤ 40mA
≤80m ﴾in open area﴿
71 x 34 x 17.5mm
51 x 12 x 13.5mm
Power Supply
Static Current
Alarm Current
Transmitting Distance
Radio Frequency
Housing Material
ABS Plastic
Operating Temperature
Relative Humidity
Sensor Dimensions (LxWxD)
Magnet Dimensions (LxWxD)
≤ 80% ﴾non‐condensing﴿
3. REMOTE CONTROL
1. Remove the activation strip from the battery
compartment.
2. Remove the backing paper from one side of each
double-sided adhesive strips. Fix one adhesive strip
to the back of the Magnet and one to the back of
the Transmitter (alternatively for permanent fixing
use the screws supplied).
3. Peel off the other side of each adhesive strip.
Mount the Magnet on the door and the
Transmitter on the door frame (small triangles
facing each other), with less than a 6mm
separation between the two.
4. When opening the door a small red indicator
lights up briefly, this indicates that the
Transmitter has sent a signal to the Control Panel.
LED
LED
Appearance
LED Indicator
Panic
Disarm
Part Arm *
(Home Mode)
Arm
Key-ring Clasp
* Note: Part Arm Function does not work
with Siren Controlled Alarm Systems