Response CWFK2 - Date;Time Setup; Motion Detection and Advance Setup

To Next Page

To Previous Page

6.6.1 Date/Time Setup

1.1 Use the left/right key to select the ‘Time Setup’ icon and press enter.

1.2 Use the left/right key to select the date or time. Use the up/down key

to set the correct digit.

1.3 Press enter to confirm settings.

6.6.2 Motion Detection and Advance Setup

When the DVR is set to motion detect, it records the photo or video by sensing any

change in picture from the selected camera and stores on to an SD memory card.

Although two cameras might be connected to the unit, it will only record from the

selected camera channel. The time and date of the capture are also recorded.

1.4 Use the left/right key to move to the

‘Motion Detect’ icon and press enter to

enable/disable auto capture.

1.5 Use the left/right key to move to the

‘Capture Format’ icon and press enter to

select ‘Photo’ or ‘AVI’ (video). Note that the AVI video clips are fixed at

a 10 second period.

1.6 Use the left/right key to move to the

‘Setup’ icon and press enter.

1.7 Press enter to select the TV system, NTSC or PAL.

1.8 Use the left/right key to move to the image

‘Quality’ icon and press enter to

select high or low quality.

1.9 Use the left/right key to move to the

‘Motion Detect Area (M)’ icon and press

enter. Use the left/right key to select the detection area (full/middle/small

area). Press enter to confirm the setting.

1.10 Use the left/right/up/down key to move the chosen detect area to a desired

target position. Press enter to confirm the setting and exit the area setup.

1.11 Use the left/right key to move to the

‘Motion Detect Count’ icon. This is used

to set the number of photos the DVR will take for every trigger when the DVR

is set to photo capture mode. The settings are 1 / 3 / 5 photo shots. Press enter

to select the required number of shots.