2. Press Menu to enter the sub-menu, "Area Setting" and
"Type Setting" shows on the display.
3. Press Up/Down buttons to select Type Setting, then
press Menu button to confirm.
4. Press Up/Down buttons to select the service type to
be modified, press Menu button to confirm.
5. Press Menu button to move the cursor position
(up to 12 characters), and press Up/Down buttons to
choose the character to be set (the characters could be
0-9, and A-Z).
6. Press Exit/Back button 4 times, back to standby mode,
the modification is finished.
·Work mode
1. Press Menu button for 2s to enter Menu list and press
Up/Down button to select Work Mode.
2. Press Menu to enter the sub-menu, "Single Key" (allow
each key on the call button to be paired with different
watch receivers separately ) and "Multi-key" (the multi-key
call button only needs to be paired with the same watch
receiver once, then the watch receiver can receive all calls
from any key on this call button) shows on the display.
3. Press Up/Down buttons to select the work mode, then
short press Menu button to confirm.
4. Press Exit/Back button twice, back to standby mode,
the setting is finished.
7
·Sequence Mode
1. Press Menu button for 2s to enter Menu list and press
Up/Down button to select Sequence Mode.
To Next Page
Loading...
