·Key Function
Set Areas and Service Types according to the needs.
·Area Setting
Set the service type corresponding to each key on the call
button in each area. (The first letter of the registered ID
indicates the area value)
1. Press Menu button for 2s to enter Menu list and press
Up/Down button to select Key Function.
2. Press Menu to enter the sub-menu, "Area Setting" and
"Type Setting" shows on the display.
3. Press Up/Down button to select Area Setting, short
press Menu button to confirm.
4. Select the Area Value which you need to change the
Service Type and press Menu to confirm.
5. Press Up/Down button to select the Service Type to be
set (40 types available), press the corresponding key on
the call button, it shows SUCCESS on the display.
6. Press Exit/Back button 4 times, back to standby mode,
the setting is finished.
Note: If you have set the service type of Area 0, and need
to set all other Areas use the same service type, choose
Copy 0 to All, press Menu to enter sub-menu, then select
Yes and press Menu to confirm will be OK.
6
·Type Setting
If none of the 40 preset service types are what you want,
you could use this function to modify the service type
according to the following instruction.
1. Press Menu button for 2s to enter Menu list and press
Up/Down button to select Key Function.
To Next Page
Loading...
