Wireless Microphone Technical Parameters:
Wireless Microphone Operation:(Limited to headset version)
1. The wireless microphone factory setting have been paired successfully, you can use it directly. If the microphone has no sound or the
microphone is disconnected, you need to manually pair it.
2.Pair the UHF manually:
Step1. Turn on the amplifier, short press “ M ” to switch to UHF mode, long press the “M” key ,the “UHF” display will flash and a voice
prompt will say, “UHF is waiting for connection”.
Step2. Turn on the wireless microphone and long press " " key for 5 seconds. The “UHF” icon will stop flashing, and a voice prompt will
say, “UHF is connected”.
Volume Control:
1.If amplifier howling or in a small volume, adjust the volume by press “+” or “-” on the wireless microphone.
2.You can also adjust the volume on the voice amplifier by rotate the volume control.
How to charge the wireless microphone:
When the microphone blue indicator light flashes means low battery. Please turn it off and charging through Micro USB with DC 5V adapter.
The red indicator light will be on all the time when charging, and it will go out after fully charged.
Notes:
1.The normal charge time is 3~5 hours. Unplug the charger as soon as it is fully charged.
2.Full charge before first use of the microphone to ensure best results.
3. Turn off the UHF wireless microphone when not in use.
Frequency response:
Sensitivity:
Working time:
Moving-coil：
30Hz-23KHz
-41dB±1dB（0dB=1V/Pa）
3-5 hours
Unidirectional
Output resistance:
Recharging voltage:
Charging time:
≤2.2KΩ
DC 5V 500mAh
2-3 hours
03
To Next Page