Retekess TR105 - Band Mode Conversion

Present recall function operation method:
Short press ⑨ MEMO button,LCD display
CH01……CH50(01……50 they are memory station address
numbers),short press VOL∧∨ for selectting the target memory
station.
10 MODE:（Mode conversion of each band）
FM state:put the 3.5mm earplug into the radio,short press the ⑩
MODE button,LCD appear “MONO” OR “ST”,each time press⑩
MODE button,two model will exchange.(“ST” is short for “STEREO”)
AM state:
short press ⑩MODE button,the LCD will display 520KHZ or 522KHZ
exchange.520KHZ it is mean the radio AM step value is 10K,
press the ⑩ MODE button,the LCD will display 522KHZ,
522KHZ it is mean the radio AM step value is 9K.
When the AM step value is 9k,the frequency range is:522-1710KHZ
When the AM step value is 10K,the frequency range is
:520-1720KHZ
Note:in the United states,Canada,Mexico,Australia and other North
American and South American countries must set to 10KHZ,other
countries must be adjusted 9KHZ.
SW state:
SW step value is 0.005MHZ，on the SW state ,short press ⑩ MODE
button it is METE cycle switching,it is convenient for search for target
station:
2.300/3.200/3.900/5.000/6.030/7.150/10.000/11.479/13.600/15.000/1
7.650/19.00/26.000.
AIR state:it is step value 5KHZ/25KHZ exchange.short press ⑩
MODE button,LCD display 05k or 25K.it is convenient.
VHF state:Narrow band FM-N and broadband FM-W
exchanged.short press ⑩ MODE button and the LCD display the
words FM-N or FM-W.
Select FM-N:Mainly used for receiving coast station/train
channel/racing channel/weather band WX/VHF intercom reception
/VHF(HAM) (for reference only!It varies from country to country,
depending on the local radio frequency.)
6