Press the UP / Down button to change another Call Tone.
Press the PTT button to confirm and return to stand-by Mode.
11, Sending a call Tone.
Press the CALL button one time quickly, the call tone will be transmitted on the
setting
channel.
12. Roger Beep On/Off
After the PTT button is released, the device will send out a roger beep to confirm
that have stopped talking.
Press the MENU button 5 times, “Ro” will be displayed.
Press the UP /Down button disable the roger beep ON/OFF.
Press the PTT button to confirm your selection and return to the stand-by mode.
13. Backlit Display
Press any button except for the MENU button to activate the back light of the
LCD display,
The back light will light on about 5 seconds.
14. Headset connection
The device can be used with headset (If there is headset packed together with
the device)The connector is located on the top of the device.
Insert the earpiece plug into the connector (2.5mm jack)
There is a small “PTT” button on the earpiece has the same function as the PTT
button on the device.
When you use the PTT button from the earpiece, you must also use the
microphone from the earpiece to talk.
Note: Don’t connect other headset, it may damage your device.
15. Battery saving function:
When the device has not been used for 6 seconds, the economy mode is
automatically activated, This does not affect the reception of transmission and
the stand by mode is automatically re-activated as soon as signal is detected.
16. Buit-in Flash light
Your device has a built-in flash light that can be used in sending light signals or
for our lighting needs.
17. Lock & Unlock the device
Press and hold MENU-button for 3 seconds to lock the device. The button lock
icon is displayed on the LCD screen.
Press and hold MENU button for 3 seconds to unlock the device.
5
To Next Page
Loading...
