6
11 Tx over time OFF Press and hold the PTT button to keep launching
15,30,…600 Value range 15~600, step value 15
12 Rx DCS OFF NO DCS
D023N,…,D754I Standard sequence of DCS
13 Rx CTCSS OFF NO CTCSS
67.0HZ,…,254.1HZ Simulate the standard sequence of mute, at the same time,
you can directly type standard or non-standard analog mute
through the keyboard
14 Tx DCS OFF NO DCS
D023N,…,D754I Standard sequence of DCS
15 Tx CTCSS OFF NO CTCSS
67.0HZ,…,254.1HZ Simulate the standard sequence of mute, at the same time,
you can directly type standard or non-standard analog mute
through the keyboard
16 DTMFST OFF OFF
DT-ST DT-ST
ANI-ST ANI-ST
DT+ANI DT+ANI
17 TONE 1000hz,1450hz, Repeater activation audio
1750hz,2100hz
18 S-CODE 1,2，…,15 When needed, send out this group of information codes
g (information codes can only be written by frequency writing
software)
19 Scan Mode TO Time Scan
CO Carrier Scan
SE Search Scan
20 PTT-ID OFF Press PTT to not send ID code
BOT Press PTT to send ID code (ID code is set by frequency
writing software)
EOT Release PTT to send ID code
BOTH ID code is sent when you press and release the PTT button
21 MDF-A Frequency In the channel mode of the A segment, the channel displays
the frequency
Name In the channel mode of section A, the channel displays the
channel name (the specific name is set in the frequency
writing software)
22 MDF-B Frequency Band B is in channel mode, the channel displays the frequency
Name In the channel mode of section B, the channel displays the
channel name (the specific name is set in the frequency
writing software)
23 Busy Lockout OFF Channel is occupied and allowed to transmit
ON Channel is occupied and transmission is prohibited
24 Key Auto Lock OFF Turn off automatic keyboard lock
ON Turn on the keyboard auto-lock function
25 Direction None In frequency mode, there is no frequency difference between
the transmitting frequency and the receiving frequency
To Next Page
Loading...
