Battery Charging
1.Take out the charger, plug the AC（100-240V）50/60Hz, then Green LED flashes;
2. Plug the battery or the radio with battery on the charger; make sure the battery is connected with the charger.
3. The charging process initiates when the red LED lights, the charging time based on the battery capacity.
The green LED lights indicating the battery is fully charged.
4. Use the USB cable to plug to the radio, red LED lights when charging, green LED lights when fully charged.
Function Operation
SWITCHING POWER ON/OFF
Turn the power switches volume control clockwise. You will hear a beep and speech, indicating the transceiver is ON.
ADJUSTING THE VOLUME
Hold Monitor button down to listen to audio level while rotating the Power switch/Volume control. Rotate clockwise to increase and co
unterclockwise to decrease volume.
SELECTING THE CHANNEL
Turn the channel switch to select your desired channel. NO.16 is Scanning Channel
PTT TRANSMIT
To transmit, press and hold [PTT] and speak into the microphone in your normal tone of voice.
SQUELCH LEVEL
the purpose of Squelch is to mute the speaker when no signals are present (Squelch OFF). With the squelch level correctly set, you will
hear sound only while actually receiving signals (Squelch ON). The squelch level can be adjusted via program software.
The frequency of squelch is 0 (on) -9 (deep), steps: 1.
SCANNING SWITCH
When radios is set as scan via software, turn the channel selector to channel 16, the transceiver will automatically detect the activity
of scanning channel from CH1 to CH15 channel (each channel can bet set scan or not via software) , When the signal is scanned channel,
the transceiver will automatically stop on the channel for the call.
a. Walkie-talkie will stay on the signal channel, when the signal disappears and then after 15s, continue scanning the next channel.
b. If there are less than 2 channels, it cannot scan.
c. On channel 16, press and hold the PTT and MONI key, it will turn on the SCAN or turn off the SCAN.
d. If the FM radio function is activated, it cannot scan.
VOICE PROMPT
a. Voice Prompt is effective when the function is turn on.
b. VOX gain level: When the sound level is higher than the set level of sound control gain, VOX automatically transmit. The gain level can
adjust from 1 to 9 levels.
c. When a signal is received, VOX will not transmit even if the sound level is higher than the set gain level.
d. On channels CH1 ~ CH5, press and hold the PTT and MONI, then switch on the transceiver, thus to activate the VOX function ON/OFF.
MONITOR
When you are receiving and no signals present, the squelch function can mute the speaker, so you cannot hear the background noise. If
you want to switch the squelch function OFF, press and hold (MONI) button. It is very helpful when you want to adjust the volume level
To Next Page
Loading...
Need help?
General
