2
Frequency Allocation
Rf power
Modulation method
Noise and harmonic
Residual Radiation
Modulation distortion
Maximum deviation
0.5W
11kΦF3E
<-40dB
≤-35dB
≤7%
≤±5KHz
TRANSMITER
The sensitivity
Modulation receiver bandwidth
Adjacent selective
Intermodulation interference resistance
Spurious response inhibition
Audio output power
Audio distortion
≤0.2uV
±5KHz
≥40dB
≥35dB
≥70dB
≥300mW
≤8%
RECEIVER
Channel
1
2
3
4
Frequency
446.00625
446.01875
446.03125
446.04375
Channel
5
6
7
8
Frequency
446.05625
446.06875
446.08125
446.09375
2. Setting volume
To set volume, adjusting [ ] [ ] button in standby
mode(Level 1 is minimum sound level while Level 8
maximum).
3. Automatic scan
Pressing and holding [ ] button for three seconds
allows to activate automatic scan. To cancel, simply
press [ ] button once again.
4. Monitoring
Monitor button [ ] can be pressed for three seconds
to activate the function of monitoring. To stop
monitoring, simply press [ ] button once again.
5. Changing channel
Every device contains its corresponding legitimate
channels in a country. Please make sure that two
radios operate on the same channel in order to talk
with each other.
To change a channel, press [ ] button to choose a
desired channel and then press PTT button to confirm
it.
This product provides one-way communication. In
other word, it cannot receive messages when
transmitting.
This equipment operates on public frequencies.
Note: Please check that current channel is available
before any transmission.
6. CTCSS/DCS
Pressing [ ] key twice and then [ ] or [ ] key
allows to choose a desired CTCSS/DCS code, which
1. POWER ON/OFF
Press and hold [ ] key for three seconds to turn on
your radio. The radio will bleep at the moment that the
screen is light.
To turn it off , Press and hold [ ] key for three
seconds.
MENU
PWR
MENU
PWR
MENU
PWR
MENU
PWR
MENU
PWR
SCAN
SCAN
SCAN
MON
MON
MON
MON
To Next Page
Loading...
