Retevis RT76P - Advanced Functions; Dual Standby and Voice Features

Dual Standby
Under this function, radio can receive frequency set by A or B channel. The operation is as follows:
(1) Under the standby condition, pressing [WJ] button, voice prompt “menu setting”, enter
functional menu settings.
(1) Pressing [ ZZQJ) or { BK@) buttons, select 7 menu numbers forward or backward. Or enter the
number 7 directly to enter the 7 menu number.
(2) Pressing [ ) button, voice prompt “Dual standby”, pressing [ JZ4J) or [ kg) button,
choose ON.
(3) Pressing [ GW) button, voice prompt “sure”, save and return to parent menu. LCD panel
display character D
Tips: Repeat operations above; choose OFF to turn off dual standby. Under the menu model, dual
standby turn off temporarily, and recover after exit.
@ Voice Compandor
Through this function, it can reduce noise of call effectively.
@ DTMFST
After it turns on, When the walkie talkie transmits, the speaker will send out the corresponding dual
tone multi frequency sound. There are three modes for monitoring side tone: Button + ID code side
tone, button side tone and ID code side tone.
25
@R-Tone
Press PTT button to send tone while holding down side button to define 1 button. There are four tone
tones, 1000HZz, 1450Hz, 1750Hz and 2000HZz, which can be selected through the menu or
frequency write software.
@ R-Code
Used to extract the edited corresponding identity code group. The ID code group can be edited by
frequency writing software. For editing method, please refer to DTMF editor description.
@ Scan Mode
There are three scanning modes: time scanning, carrier scanning and search scanning
1. TO, stay for a while after scanning the signal, and then continue scanning
2.CO, stop scanning after scanning the signal until the signal disappears
3. SE, the search mode scans and searches the signal and stays in the current channel
@ ANI Match
After turn on this function, the machine recognizes the effective identity code, the caller ID /
GROUP / ALL/ CALL will be displayed on the screen. After the effective ID is recognized, the
machine will turn on the horn and reset the effective TOT (5S). That is to say, ifa valid ID is
recognized or a call is initiated actively, the horn can be turned on within 5S without ID recognition.
@ Setting Methods of All Call / Group Call / Groups Call / Single Call
At the same time of launching, directly input the call ID code on the keyboard. For example, all
members in a certain place are divided into 6 groups and 2 groups. Each group has 5 members.
26