Recording Video
1. Press the “Video” button until the LED Status Indicator lights up red and flash. The camera will beep audibly.
2. The camera will enter into Video Recording Mode and begin to record. It will save a file every
3min/5min/10min/20min. The recording time can be set in video setting menu list.
Note: If you have set the Auto night vision in the system setting list to be Manual. When the lighting is insufficient,
press the Up/IR button can enable Night Mode and the IR LEDs. If you have set the Auto night vision to be Auto.
When the lighting is insufficient, the camera will automatically enable Night Mode and the IR LEDs. It will
automatically return to the normal recording mode when light conditions improve.
Stop Recording Video
1. Press the “Video” button until the LED Status Indicator Lights up green.
2. The camera will enter Recording Standby Mode.
Recording Audio
1. Press the “Audio” button until the LED Status Indicator flashes green.
2. The camera will beep, the LCD screen will show the Audio Recording Mode Screen to indicate it has begun
recording audio only.
Stop Recording Audio
1. Press the “Audio” button until the LED Status Indicator shows solid green.
2. The camera will enter Recording Standby Mode.
Taking a Photo
1. When the camera is in Recording Standby Mode or during Video Recording Mode, press the “Photo” button to
take a photo.
2. The LED Status Indicator will flash green once if take a photo in Recording Standby Mode. There is photo
capturing sound when taking a photo.
Files Playback
1. Long press the “OK/Playback” button until the camera enters into Playback Mode.
2. To play the currently recording file, press the “OK” button again.
3. To play another file, use the “UP” or “Down” button to cycle through the files. Press the “OK” button when you
have found the file to play it.
Exit Playback Mode
1. To exit the Playback Mode, long press the “OK/Playback” button.
2. The camera will return to the Recording Standby Mode.
Charging Battery with USB Cable
1. Connect a USB cable with a compatible connector to a computer/wall charger.
2. Connect the USB cable to the USB port on the body camera.
Battery Status Icons
Low Power Not Fully Charged Fully Charged
To Next Page
Loading...
Need help?
General