4
INSTRUCTION MANUALEN
FEATURES
• Officially-licensed SEGA® controller featuring Bluetooth® technology
• Compatible with Steam®, PC/Mac®, Android® and Switch
• Rumble capability on supported games
• 30ft / 10m range
• 550 mAh rechargeable battery
• Micro USB® charge cable
• Up to 20 hours of gameplay on full charge
• Features Home & Select buttons and X-input/D-input modes
• Compatible with the original Sega® consoles via Retro-Bit® Receiver with Bluetooth®
technology (sold separately)
OPERATION
• Power On - Press Home for 1 second to power on. The four LEDs will flash once.
• Power Off - Press and hold Home for 3 seconds to power off the controller.
• Charging - Plug in the Micro USB® cable from the controller into a powered, open USB®
slot. If the controller is synced via a Bluetooth connection to a console and powered on, you
can charge and play.
• Low Power - Plug in the Micro USB® cable from the controller into a powered, open
USB® slot. If the controller is synced via a Bluetooth connection to a console and powered
on, you can charge and play.
• Sleep Mode - Controller will enter Sleep Mode if unpaired without a signal for 10 seconds,
if paired but no buttons pressed in 6 minutes, or if paired but without a signal for 3 minutes.
When in Sleep Mode, press Home once to wake up controller.
CONNECTING TO DEVICES
SWITCH
1. Go to the Switch Home and go to Controllers, then to Change Grip/Order.
2. Press Home + Y to turn on the controller. The LEDs will go into Search mode and vibrate
when connected. The appropriate player # LED will remain on.
3. The controller will auto-reconnect to the console when woken up with Home until you sync
the controller to another device.
4. To switch the D-Pad to Left Analog mode, press and hold L + R + Start for 5 seconds. The
controller will vibrate once to indicate it has switched. Repeat process to return to D-Pad
mode.
5. To swap A-B and X-Y, press and hold
↓
+ Start for 3 seconds. Repeat the process to
change it back.
To Next Page
Loading...