RetroSound Model Two - Adjust Fit for Vehicle Specific Kit

INSTALLATION INSTRUCTIONS
Rear USB Inputs
Two USB connector cables are located at the rear of the Motor 3 radio
ERG\'XULQJLQVWDOODWLRQ\RXPXVWURXWHWKHFDEOHVWRDFRQYHQLHQW
DQGDFFHVVLEOHORFDWLRQIRUSOXJJLQJLQ86%GHYLFHV,IWKHFDEOHV
SURYLGHGDUHQRWORQJHQRXJKLQFKHV\RXPD\XVHRXURSWLRQDO
86%$8;([WHQVLRQ&DEOHWRH[WHQGWKHUHDFKRIWKHFDEOH7KLVFDEOH
DOVRDOORZV\RXWRLQVWDOOWKH86%$8;SRUWLQWRWKHIDFWRU\ORFDWLRQIRU
WKHFLJDUHWWHOLJKWHUIRUDIDFWRU\ORRNDQGHDV\DFFHVV
67(3)LQLVKWKH,QVWDOODWLRQ
IF USING A BEZEL3ODFHWKHEH]HORQWKHIDFHRIWKHUDGLR,QVWDOOWKH
assembled radio from behind the dash until the bezel and radio face
DUHÁXVKZLWKWKHIURQWRIWKHGDVKDQGWKHUDGLRVKDIWVSURWUXGHWKURXJK
WKHVKDIWRSHQLQJVLQWKHGDVK8VLQJWKHVXSSOLHGZDVKHUVDQGVKDIW
QXWVVHH´:KDW·V,QWKH%R[µRQSDJHVHFXUHWKHUDGLRWRWKHGDVK
IF USING A FACEPLATE, slide the radio into the hole from behind the
GDVKWKHQDOLJQWKHIDFHSODWHRYHUWKHUDGLRVKDIWVIURPWKHIURQW
Using the supplied washers and shaft nuts (see “What’s In the Box” on
SDJHVHFXUHWKHIDFHSODWHWRWKHGDVKDQGWKHUDGLR
'$0$*(5(68/7,1*)52029(57,*+7(1,1*7+(6+$)71876
:,//92,'<285:$55$17<
Finally, you’ll need to secure the rear of the radio using the supplied
EDFNVWUDSDQGKDUGZDUH6HH´:KDW·VLQWKH%R[µRQSDJH7KH
back strap mounts using the threads in the rear of the radio body and
can be bent and adjusted to align with the mounting point of the
RULJLQDOIDFWRU\UDGLREHKLQGWKHGDVK1RZ\RXFDQLQVWDOO\RXUNQREV
The included shaft covers may be used to cover up excess shaft metal
GXULQJ\RXULQVWDOODWLRQ7KH\FDQEHFXWWRDQ\OHQJWKWRFRQFHDOWKH
VKDIWDQGPDNHWKHLQVWDOOORRNPRUHSURIHVVLRQDO
Slide the rear knob over the shaft, rotating it into the correct position,
DQGSXVKLWLQWRSODFH0RXQWWKHIURQWNQREE\JHQWO\SUHVVLQJRQWR
WKHVKDIW