2. Remove the leash, rinse with fresh water and let air-dry before storing in the rucksack
backpack.
3. Detach / break down 3 piece paddle. Rinse inside and outside with fresh water and let
air-dry before storing in the rucksack backpack.
1. Clean and Dry the Board:
With the board inflated and the valve closed, rinse the board with fresh water to clean it of
any sand or debris. Allow the board to dry completely. Do not store board while still wet to
prevent mildew build up.
2. Deflating the Board:
Once the valve area is dry, remove the valve cap, keeping your face away from the valve
as the air will escape rapidly at first and could cause harm.
Press down lightly on the inflation valve stem to release some of the air - which will
slow down after the initial strong burst.
Press and turn the inflation valve stem to lock the stem in the open (DOWN) position to
fully deflate the board.
3. Rolling up the Board:
With the board deflated and the valve still open, start at the nose of the board,
opposite from the valve. Fold 3 in. over and roll up the board until reaching the valve.
Close the valve stem by turning the inflation valve stem to the UP / closed position and
replace the valve cap.
Wrap the strap around the rolled-up board and fasten the buckle.
Storage
Place your SUP back into its rucksack backpack and store in a safe place. Make sure it is
protected from the elements, extreme heat or cold.
8
To Next Page
Loading...