Weekender
10’6”
Weekender
Plus 10’6”
Weekender
Yogi 10’
Weekender
Tour 11’6”
Weekender
Nano 8’
Weekender
Crew 12’
Weekender
Crew XL 15’
Weight Limit
lbs.
275 300 275 300 140 500 1200
PSI
Recommended
15 12 15 15 15 12 12
Fin Installation
Tri-Fin & 5 Fin Models:
1. Slide the central fin into the center mounting slot and lock in place by inserting the
locking pin into the base.
2. Slide the two smaller outer fins (4 fins for Weekender Crew) into the two side slots (4 for
Weekender Crew) and lock in place by inserting the locking pins into the bases.
3. Some force may be necessary to fully insert the fins into their slots.
4. Always wiggle the fins to be certain they are securely attached before using the board.
Single-Fin Model:
1. Remove the thumb screw and square washer from the fin.
2. Insert the washer into the fin box track so that it is flat on the bottom of the track. Slide it
to the front of the fin box.
3. Insert the base of the fin and align the small hole in the front of the fin with the hole in the
washer at the front of the fin box.
4. Insert the thumb screw and secure by tightening until it is firmly screwed into the washer.
5. Always wiggle the fin to be certain it is securely attached before using the board.
Leash Attachment
1. Locate the leash string and thread it through the D-ring at the tail of your board. Loop the
string back through itself so that it makes a loop. Open the folded velcro closure and insert it
through the loop in the leash string. Secure the leash by folding the velcro closure pieces in
sequence, and press firmly to close.
2. Attach the leash cuff around your ankle, making sure the coiled part is in back.
3. Make sure you use the proper leash for the water conditions you are paddling in! Refer to
above, "Always wear a leash."
Deflation and Storage
Fins, Leash, and Paddle
1. Fin Removal
Tri-Fin & 5 Fin Models:
Lay board with fins facing up on a clean flat surface free of any debris or sharp objects.
Remove the center and side fins by pressing the tabs on the locking pins and sliding them
out of their mounts. Store fins in rucksack backpack until next use.
Single-Fin Model:
Lay board with the fin facing up on a clean, flat surface free of any debris or sharp objects.
Unscrew the thumb screw from the washer. Remove the fin from the fin box. Remove the
washer from the fin box track. Attach the washer and thumb screw to the fin for storage and
stow in rucksack backpack until next use.
7
To Next Page
Loading...