Need help?Do you have a question about the Retsch ZM200 and is the answer not in the manual?
Crucial guidelines and tests that must be performed during any repair procedure.
Detailed steps for replacing the main control board (GP2).
Detailed guide on how to replace the main motor of the device.
Comprehensive list of error codes with causes and recommended solutions.
General| Type | Ultra Centrifugal Mill |
|---|---|
| Feed material | soft, medium-hard, brittle, fibrous |
| Size reduction principle | impact, shearing |
| Max Feed Size | 10 mm |
| Speed Range | 6, 000 - 18, 000 rpm |
| Material of sieves | Stainless steel |
| Applications | Agriculture, Food, Plastics |
| Rotors | 6-teeth rotor, 12-teeth rotor |
| Material of grinding tools | Steel, Stainless steel, titanium |
| Sieve sizes | 0.08 mm - 10 mm |
| Collector volume | 5 L |
| Drive | Three-phase motor |
| Drive power | 1.1 kW |
To Next Page
