Retsch ZM200 - Page 47

Changes
47
5 Changes
Change index “C”
 05.748.0101 main board for the frequency converter 02.199.0005 has been changed
Main board fuse 0.16A T changed to 0.25A T, VDR resistance eliminated
 03.105.0342 frequency converter cable 02.199.0005 changed
1 VDR resistance inserted into each of all 3 wires
Change index “D”
 05.748.0101 frequency converter main board changed
The control has been given an additional capacitor
Change index “F”
 A partition wall has been added, retrofit kit 22.823.0009
Change index “G”
 Motor changed, now 02.441.0399
Change index “H”
The cable 03.105.0342 changed, neutral and phase bridged with a VDR resistance
 Firmware update to Version 1.52
Change index “I”
 The Siei frequency converter assembly was replaced with the Fuji assembly
Please use the Retrofit kit 02.199.0008
See chapter 3.5 conversion of the frequency converter from Siei to Frenic-Mini
Change index “L”
 Replacing the motor flange 03.443.0015
 Replacing the labyrinth disc 02.706.0270
 Replacing the sealing ring for the cartridge with foam rubber 03.114.0092
Change index “O”
 Replacing back plane RS485 is no more longer necessary
Change index “P”
 The main board GP was replaced with the GP2 control board
Please use the item number 05.748.0179
See chapter 3.3 Replacing the Control PCB GP2
 Firmware update to version 4.01
Change index “Q”
 The main board GP2 05.748.0179 was replaced with the GP2 board TFT 05.748.0193
 Display TFT 02.569.0019 – display required GP2 board for TFT
 Now free access to the main fuses on the backside of the ZM200
 Firmware update GP2 board version V01.06
 Firmware update TFT display version V01.04