19
GB
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
CLEANING
WEEE DISPOSAL INFORMATION
According to the European regulations, used electrical and electronic equipment may no longer be put out into
unsorted rubbish. The symbol on the wheeled rubbish bin points out the necessity for separated collection. Help
us to protect the environment and ensure that this unit is put out in the appropriate systems for separate collection
once you do not use it any longer. DIRECTIVE OF THE EUOROPEAN PARLIAMENT AND COUNCIL of 4th July 2012
concerning used electrical and electronic equipment (S7).
SERVICE
BATTERY DISPOSAL INSTRUCTIONS
If you have any questions concerning our products or a complaint, then please go to www.rev.de to find out how
to make contact or how to organise a return. Alternatively, send an email to service@rev.de. We’d like to point out
that we are unable to process any shipments which do not have a return number and will not accept them.
Batteries and rechargeable batteries must not be disposed of with household waste. Every consumer is legally
obliged to dispose of all batteries and rechargeable batteries, whether or not they contain harmful substances,
to a suitable commercial or municipal collection point municipality/district so that they can be disposed of in an
environmentally friendly manner. Batteries and rechargeable batteries should only be returned in a discharged
state (S8)!
You suspect electrical
lines, but the device
does not detect any.
•Conduits can be
shielded by metal pipes,
braided shields, metal
wall coverings, plywood
walls, or other dense
materials.
•Lines deeper than
51mm from the surface
may not be detected.
•Lines may not be
active.
•Scan the area again in metal scan mode to see if you find
any metal, conduit, or metal pipes.
•Be especially careful if the area has plywood, thick wood
beams behind drywall, or thicker than normal walls
•If a switch controls an outlet, make sure it is on for
detection, but off when working near electrical wires.
WARNING: Use caution when nailing, screwing, or sawing
into walls, floors, or ceilings where wiring may be present or
you suspect it.
Device indicates low
battery and does not
work.
•The battery level is too
low for measurement.
•Replace the battery with a new 9V block of the same type.
The indicator bars
on the display flash
during scanning.
•The instrument was
calibrated near or over
a bar and then moved
away.
•The wall is not flat.
•Move the device to another location and perform the
calibration again.
•Recalibrate the instrument at the point where the indicator
bars were flashing.
No indicator bars on
the display during
scanning.
•Calibration was not
performed correctly.
•The bar is too deep
below the surface for
the bar scan mode set.
•Rerun the calibration at a different location.
•Select a greater scan depth, recalibrate the device, and
scan again.
To Previous Page
Loading...