4 // for tips, tricks, and answers to FAQs, visit myrevair.com
REVERSE-AIR
Tension (Reverse-Air) settings are
located on the triangular Base.
To set your tension level, power
on your Reverse-Air Dryer
Base; after the HELLO message
appears, press the (+) button until
your Reverse-Air Tension is set
to Level 3.
SETTING UP FOR SUCCESS
Follow these essential tips to achieve your best results.
WASHDAY
Wash hair. Towel dry. Detangle.
RevAir works best on clean, towel-
dried hair with a light leave-in
product applied.
Do not oversaturate hair with any
product or water to the point of
excess dripping.
Application of products with sticky
xatives prior to Reving is not
recommended.
Section size should not exceed
the size of the Wand opening.
If your hair has a lot of density or
volume, start with slightly smaller
sections to allow free/unrestricted
airow within the Wand.
SECTIONING
Should a section of hair be
too large in volume, the Heat
Chamber will shut down,
indicating the section size should
be reduced.
Simply remove the hair section
and retry with less hair. The Heat
Chamber function will reset and
resume automatically.
DO NOT immediately start at
Level 7. Oftentimes, less is more.
Note // The Wand includes an
internal sensor to monitor heat
levels, minimizing heat exposure.
Level 3
Setting
To Next Page
Loading...
