RevAir Reverse-Air - Heat Level

looking for a specic solution? visit support.myrevair.com // 5
OPTIMIZING RESULTS
Follow these essential tips to achieve your best results.
II
=
220°F/105°C
O
=
No Heat | Cool Shot
I
=
158°F/70°C
TECHNIQUE
RevAir uses technology that is
incredibly different from other
tools - and it can take a bit of time
to perfect your technique!
Insert a section of hair into the
Wand until the Wand Mouth
reaches the scalp.
Keep Wand at/near the scalp,
allowing the Reverse-Air to do
the work. Gently move the mouth
of the Wand across the section at
the root.
No need to pump, bounce, or
swirl the Wand.
HEAT LEVEL
Toggle the Temperature Control
button on the Wand to the ( II )
temperature setting.
Most RevAir users prefer this
setting to achieve the smoothest
nish.
CAUTION // To avoid overheating,
setting ( II ) should only be used
when the tension is set between
Level 3 - Level 7.
Note // Should you experience
even a tiny tangle, the tension
setting should be lowered.
RESULTS
Drying times vary by hair type but
commonly range from 30 to 90+
seconds per section.
To ensure a section is dry, pull the
Wand a few inches from the scalp
to feel for dampness.
If you still have a bit of dampness,
repeat until hair feels dry, noting
the time it took to get it just right.
Once dry, pull the wand away
from the scalp, comb through,
and move to your next section.
If you are seeking sleeker, less
textured results, increase your
tension level for the next section.
Keep experimenting until you
unlock your unique setting
combination.