Need help?Do you have a question about the Revez HD400MOD and is the answer not in the manual?
Connect to mains supply, ensure correct connection, disconnect before maintenance.
Avoid overvoltage to prevent short circuits or fire. Never overload power lines.
Protect module from splashes. Do not place liquid containers on the module.
Disconnect before cleaning. Use only a humid cloth without solvent.
Ensure adequate air circulation, do not obstruct holes. Avoid sealed environments or heat sources.
Use only manufacturer-approved accessories to prevent module damage.
Install in a protected place, avoid direct sunlight, humidity, heat. Keep 10cm from radiation sources.
Details DC input, USB, RF input/output, and HDMI ports on the device.
Identifies the display and control buttons (Cancel, Enter, Up/Down) on the front panel.
Connect HDMI, RF cables, and a terminator if RF input is unused. Then connect power.
Connect power supply. Display shows REVEZ logo, then the main menu.
Overview of main menu and sub-menus (DVB, A/V, TS, Language, Default Config) for parameter access.
Configure output frequency, bandwidth, attenuation, mode, constellation, FEC, and guard interval.
Adjust video bit rate, audio bit rate, and audio compression type (AAC-LC, MPEG1-L2).
Configure transport stream parameters: IDs, names, LCN, service name, and PIDs.
Select the preferred language for the user interface.
Restore all settings to factory defaults, losing current modifications.
Use TMHDIface software via USB to configure the HD400MOD from a PC.
To Next Page
General