REXROTH IndraControl L45

Need help?

Do you have a question about the REXROTH IndraControl L45 and is the answer not in the manual?

Summary

Product identification and scope of delivery

2.1 Product identification

2.2 Scope of delivery

Use of the safety instructions

3.2 Explaining signal words and safety alert symbol

Defines signal words (danger, warning, caution) and alert symbols.

Intended use

Technical data

7.1 General technical data

7.2 Voltage supply and current and power consumption

Lists voltage, current, and power consumption parameters.

Interfaces

9.1 Interface view

9.2 Overview

Mounting, demounting and electric installation

10.1 Installation notes

Provides essential guidelines for safe and effective installation.

10.3 Mounting the control

General information and steps for mounting the control unit.

10.3.2 Mounting the control on the top-hat rail

Describes the procedure for attaching the control to a top-hat rail.

10.3.3 Mounting Rexroth Inline terminals (optional) in series

10.3.5 Mounting function modules (optional)

10.5 Demounting the control

Outlines steps for removing the control unit.

10.5.2 Removing the first Rexroth Inline terminal

10.5.3 Removing control from top-hat rail

Explains how to detach the control from its mounting rail.

10.6 Demounting and changing the Inline terminals

Covers the procedures for removing and replacing Inline terminals.

10.6.1 Removing an Inline terminal

10.6.2 Changing an Inline terminal

10.7 Electric installation

Essential information for wiring and electrical connections.

10.7.1 General information

General safety warnings and requirements for electrical installation.

10.7.2 External power supply unit

Information on using the specified power supply unit.

10.7.3 Voltage supply for the control

Details on powering the control unit and its modules.

10.7.4 24 V voltage supply

Specifics on providing 24V DC supply, including isolation options.

10.7.5 Grounding

Guidelines for proper grounding to ensure noise immunity.

10.7.6 Shielding

Instructions for effective shielding to reduce interference.

10.7.7 Connecting lines to tension spring connection points

Steps for connecting lines to tension spring terminals.

10.7.9 Digital onboard inputs

10.7.10 Digital onboard outputs

Commissioning

11.1 General information

Important notices regarding the commissioning process.

11.2 Commissioning steps

Step-by-step guide to commission the control unit.

Error causes and troubleshooting

Maintenance

14.1 General information

14.2 Regular maintenance tasks

Outlines routine maintenance checks and procedures.

Service and support

Service Germany

Service worldwide