3
8. Connect the coax connector to the new LNB. When looking at the LNB (white plastic circles) port one (1)
is on the far LEFT – if using a single coax place connector on this port.
9. Splice the Black and Red wires using the Scotch-Lok connectors (red button). It is not necessary to strip
the wires. Place the ends of the wires deeply into the connector and pinch with pliers. This will connect
the LED’s that will reflect onto the dish at night. Tuck the Scotch-Lok connectors through the hole in the
dish.
10. Route the Cable Loom down either side of the LNB Arm and secure with Cable Ties (provided).
PORT 1
To Next Page
Loading...
Need help?
General
