ELITE Remote control System
Quick Installaon Guide (systems only)
The Elite system provides 4 switches each capable of switching up to 1KW (4A @ 230V). Each channel is independ-
ent and separately controlled. The ELITE Remote control system provides 230V mains switched outputs via each ter-
minal.
1. First mount the ELITE system receiver box in the wall in your desired locaon.
2. Open the enclosure by removing xing screws from the enclosure front and then removing the front from the
enclosure.
3. Wire the LIVE, Neutral and Earth connecons to the power supply screw terminal as shown below
(shown as A).
4. Wire your load(s) as required (shown as B).
5. Once all required wiring is complete, use the handheld ELITE transmier to switch the outputs on and o.
6. As supplied, the handheld will operate the outputs - Buon 1 to output 1, Buon 2 to output 2 etc.
7. All buons will operate in a latching mode - Press for on, press again for o. It is possible to change the operaon
to momentary mode by ng the links (shown as C)
8. For advanced operaon such as adding extra transmiers dierent buon mapping opons consult
datasheet.
Fig 1.1
Please contact RF Soluons if any components are missing
Sales: +44 (0) 1444 227910 Tech. Support: +44 (0) 1444 227909
QS-ELITE-4
ELITE Remote Control System
Quick Start Guide
What’s in the box?
1 x Receiver with 5 addional
cable glands
1 x Transmier (system only)
Please contact RF Soluons if any components are missing.
Sales: +44 (0) 1444 227900 Tech Support: +44 (0) 1444 227909
or
ELITE Remote
Control System
Quick Start Guide
For full details of ELITE’s
programmable features, see
the ‘ELITE Datasheet at
www.rfsoluons.co.uk.
To Next Page
Need help?
General