RF REGIMEN MANUAL | 17
Step 8: Press the “function” key on your device (ONCE if the
device is on MODE 2. If the device is off, push the POWER button,
and the function key THREE TIMES). This initiates MODE 3 (Blue
LED + Cooling) on your RF DEVICE. For three minutes, apply
a light pressure while slowly moving the applicator in small,
circular motions on your desired treatment areas. The device
will automatically shut off after ve minutes. For additional
treatment time while in MODE 3, you may power the device on
once again, and continue for no longer than 10 minutes in total.
Step 9: You have now completed your treatment.
To Next Page
Loading...