TABLE OF CONTENTS
SECTION 1 - GENERAL INFORMATION
1.1 INTRODUCTION Page 3
1.2 DESCRIPTION Page 3
1.3 SPECIFICATIONS Page 4
SECTION 2 - INSTALLATION
2.1 INTRODUCTION Page 5
2.2 UNPACKING AND INSPECTION Page 5
2.3 PREPARING FOR INSTALLATION Page 5
2.4 POWER REQUIREMENTS Page 5
2.5 POWER CONNECTIONS Page 8
2.6 READER WIRING Page 9
2.7 READER CONNECTIONS Page 10
2.8 ABOUT ENABLE & ENABLE REMOTE Page 10
2.9 ABOUT SHIELDING Page 11
2.10 MATING THE INTERFACE TO A COMPUTER Page 11
2.10.1 SETTING SERIAL TYPE Page 11
2.10.2 ASCII FORMAT Page 12
2.10.3 DATA TRANSFER RATES, BAUD Page 13
2.10.4 SERIAL CABLING Page 13
2.10.5 SERIAL CONNECTION Page 14
2.11 DEFAULT OPERATING MODE Page 15
2.12 AUXILORY PORT FOR LCD Page 15
2.13 INSTALLATION COMPLETE Page 15
SECTION 3 - OPERATION
3.1 INTRODUCTION Page 16
3.2 THEORY OF OPERATION Page 16
3.3 TIMING Page 17
3.3.1 WORSE CASE TAG REPORT TIMING Page 17
3.3.2 TIMING SUMMARY Page 19
3.4 DATA PROTOCOL Page 20
3.5 ISSUING COMMANDS TO THE INTERFACE Page 20
3.6 INTERFACE RESPONSES Page 25
3.6.1 TAG DATA Page 25
3.6.2 ERROR MESSAGES Page 26
3.7 WARRANTY Page 27
If you are reading a pdf version of this manual you may notice page numbers and the above contents to
be off by a page from time to time. The conversion to Acrobat has a tendency to move sections as the
fonts don’t translate perfectly.
To Next Page
Loading...