RFL IMUX 2000 User Manual

62 pages

To Next Page

Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and speciﬁcations without notice.

RFL Electronics Inc.

IMUX 2000

SNMP Access Gateway

User’s

Manual

RFL Electronics Inc.

353 Powerville Road

Boonton Township, NJ 07005

(973) 334-3100

Publication No. MC2000SNMP

Printed In U.S.A.

Revised August 10, 2009

Default Chapter3
- Table of Contents3
Chapter 1 - Product Overview7
- Introduction7
- IMUX 2000 Information8
Chapter 2 - Installation9
- Mounting9
- Power Input9
- Serial Ports10
- Ethernet10
- Front Panel Items11
Chapter 3 - Basic Setup for Operation13
- Network Setup13
- Local Command Mode13
- Connections14
Chapter 4 - Command Control15
- Command Processor Mode15
- General Commands16
- Pseudo-SNMP Commands17
Chapter 5 - Use of the Setup Menu19
- Networking19
- Serial/Input Ports21
- Passwords22
- Event Definitions22
- Action Definitions24
  - Traps25
  - Pagers25
- System Date/Time26
- General Settings26
Chapter 6 - Pass through Mode28
Chapter 7 - Console Mode30
Chapter 8 - Management Information Base (Mib)31
Chapter 9 - Snmp Configuration and Control35
Chapter 10 - Using Ftp46
Chapter 11 - Programming Data Alarms47
- Alarms Are the same as Events47
- Alarm Actions47
- How Data Alarms Are Set up47
- Defining Data Alarms47
- Field Section48
- Operators for Formulas48
- Macro Section49
- Data Alarm Section49
- End Section50
- Defining Alarm Actions50
Chapter 12 - Use of the Events Command51
- List Events File51
- Clear Events File51
- View Active Alarms51
- Acknowledge Active Alarms52
- View Alarm Action Detail52
- View Data Alarm Counters52
- View Action History52
- Clear Action History53
Chapter 13 - Resetting the Snmp Access Gateway54
Chapter 14 - Application Notes55
App Note A. Use of Ip Restrictions56
App Note B: Monitoring Rs232 Levels as Alarms57
- Sensor Inputs57
App Note C: Imux Trap Messages58
- Trap Format58
- Trap Codes59
- Trap Configuration Information59
- MIB Information59
Chapter 15 - Warranty Information60
Chapter 16 - Canadian Dept. of Comm. Notice61

Other manuals for RFL IMUX 2000

Instruction Manual1105 pages

Questions and Answers:

K
kellyginaAug 17, 2025
What to do if RFL IMUX 2000 Multiplexer has equipment problems?
- J
  Jaime SchmidtAug 17, 2025
  If you are experiencing equipment problems with the RFL Multiplexer, replace the faulty module or modules with spares.
H
hbutlerAug 19, 2025
What to do if there are setup problems with RFL IMUX 2000?
- A
  Anna ChapmanAug 19, 2025
  If you are experiencing setup problems with the RFL IMUX 2000 Multiplexer, reconfigure the multiplexer or multiplexers that are not set up correctly.