To Next Page
K
kellyginaAug 17, 2025
What to do if RFL IMUX 2000 Multiplexer has equipment problems?
- JJaime SchmidtAug 17, 2025
If you are experiencing equipment problems with the RFL Multiplexer, replace the faulty module or modules with spares.
What to do if RFL IMUX 2000 Multiplexer has equipment problems?
If you are experiencing equipment problems with the RFL Multiplexer, replace the faulty module or modules with spares.
What to do if there are setup problems with RFL IMUX 2000?
If you are experiencing setup problems with the RFL IMUX 2000 Multiplexer, reconfigure the multiplexer or multiplexers that are not set up correctly.
What to do if RFL IMUX 2000 has public network problems?
If you are experiencing public network problems with the RFL Multiplexer, work with your Local or Inter-exchange carrier to correct the situation.
What to do if RFL Multiplexer has private network problems?
If you are experiencing private network problems with the RFL Multiplexer, consult the network manager.
What to do if RFL Multiplexer has channel troubles?
If you are experiencing channel troubles with the RFL IMUX 2000 Multiplexer, check to see if similar troubles exist on other channels. The cause is probably a E1 circuit or IMUX 2000 Common Module failure.
What to do for low bit error rate on a data channel of RFL IMUX 2000 Multiplexer?
If you are experiencing a low bit error rate on a data channel with the RFL Multiplexer, try in-service E1 circuit monitoring before performing out-of-service testing.
What to do if RFL IMUX 2000 has E1 circuit errors?
If you are experiencing E1 circuit errors with the RFL Multiplexer, perform in-service monitoring on the E1 facility.
What to do if RFL IMUX 2000 has Loss of Carrier at the Common Module?
If you are experiencing Loss of Carrier at the Common Module of RFL Multiplexer, check for presence of carrier. The cause may be low received signal power level or low 1’s density.
What to do if RFL IMUX 2000 Multiplexer has high error rate or loss of frame synchronization?
If you are experiencing a high error rate or loss of frame synchronization with the RFL Multiplexer, use the loopback procedure to isolate the fault.
What to do if RFL IMUX 2000 has power-related problem?
If you are experiencing a power-related problem with the RFL IMUX 2000 Multiplexer, verify that the POWER LED on the IMUX 2000 Main Shelf is on. The cause is that the POWER LED is off.
General| Brand | RFL |
|---|---|
| Model | IMUX 2000 |
| Category | Multiplexer |
| Language | English |
