Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
6.2 SOFTWARE INSTALLATION
This section describes how the IMUX 2000 Network Management Software (NMS) is installed into your
PC. The following procedure can also be used to install updated NMS programs into your PC as they are
released.
Before attempting to install the software into your PC, there are some important facts that must be
considered:
1. The software is shipped from the factory on one CD, labeled “SW2000NMXXX”.
2. Before loading the software make a working copy of the CD. Store the original CD in a
safe place, and use the working copy to load the software into the PC.
3. Before installing the software, it is recommended that you run CHKDSK or SCANDISK to
verify that no problems exist on your hard disk, and to verify available disk space. You will
need about 40 megabytes free for a complete installation.
4. As you are installing the software, several lists of choices will appear on the screen; the
exact lists displayed will depend on whether you are installing the software for the first time
or replacing an existing version. Read the instructions below each list carefully before
making your choice.
5. If this is a new installation, proceed as described in paragraph 6.2.1. If you are upgrading to
a new NMS version, un-install the old NMS version as described in paragraph 6.2.2, install
the new NMS version as described in paragraph 6.2.1, and then use the “Update Config in
Memory to New Version” option as described in Help.
6.2.1 INSTALLING THE SOFTWARE
1. Insert the CD into the CD ROM drive.
2. In most cases, a setup window will appear on the screen. If not, do the following:
a. From the Start Menu, select Run.
b. The Run window will appear on the screen.
c. Type the following in the command line: d:\setup
d. Then click on OK.
3. Click on Next to continue with the setup.
4. From this point on the Installation Software will prompt you to enter the information it
needs to install the software into your system. When the installation is complete, the
Network Management Icon will be displayed in the Program Manager window.
5. This completes the installation of the Network Management Software.
IMUX 2000E1 RFL Electronics Inc.
February 28, 2006 6-2 (973) 334-3100
To Next Page
Loading...
