Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
7.7.2 DETERMINING CHANNEL MODULE CONFIGURATION
To determine the configuration of a given channel module in an IMUX 2000 Series multiplexer, issue
a CONFIG? command in the following form:
<Address>:Cn:CONFIG?:;
where n is the number of the target channel module. For example, to determine the setup of a channel
module #4 in multiplexer #20, issue the following command:
20:C4:CONFIG?:;
The response to a valid channel module CONFIG? command has the following general form:
* OK
CHANNEL CARD nn, TYPE mmm
UNDER REMOTE (or LOCAL) CONTROL
SRVC = ON (or OFF)
(one or more lines stating the values of each "P" [setup] parameter);
7.7.3 CHANGING CHANNEL MODULE CONFIGURATION
The configuration of a channel module can be changed by issuing SET commands with the appropriate
subaddress and parameter. For example, to turn off (disable) channel module #4 in multiplexer #20,
you would issue the following command:
20:C4:SET:SRVC = OFF;
IMUX 2000E1 RFL Electronics Inc.
February 28, 2006 7-28 (973) 334-3100
To Next Page
