Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
Section 6. NETWORK MANAGEMENT SOFTWARE
6.1 GENERAL INFORMATION
The IMUX 2000 Network Management Software is a software program which uses the Microsoft
Windows operating system. It enables the user to perform several different tasks related to the IMUX
2000 Multiplexer, Intelligent Line Switch and DACS when in a system configuration. A brief
description of these tasks is listed below. A more detailed description of how these tasks can be
implemented is discussed later in this section.
1. Enables the user to communicate with all IMUX 2000 units located in a network.
2. Enables the user to communicate with all intelligent channel cards located in each
multiplexer.
3. Enables the user to view a graphical picture of the system from any node.
4. Enables the user to access information regarding the configuration of any node in the
network.
5. Enables the user to customize the software for specific requirements.
6. Enables the user to change card parameters in real time.
7. Enables the user to perform network troubleshooting and maintenance.
6.1.1 SYSTEM REQUIREMENTS
In order to use the Network Management Software your PC must meet the following minimum
requirements:
1. The PC must be IBM compatible with a hard disk drive and a CD ROM drive.
2. The PC must use an Intel Pentium microprocessor or higher.
3. The PC must have a minimum of 8MB of RAM (16MB of RAM preferred).
4. The PC must have Windows 98, Windows 2000, Windows NT, or Windows XP.
5. The hard disk must have at least 40 megabytes of free disk space for the IMUX 2000
Network Management Software.
IMUX 2000E1 RFL Electronics Inc.
February 28, 2006 6-1 (973) 334-3100
To Next Page
Loading...
