TECHNICAL DATA
-Frequency Coverage: 1.5 to 55 MHz (all amateur frequencies)
-Operation Mode: All modes
-Filter Bandswitch: Automatic for YAESU and ELECRAFT transceiver – Manual for any other brand
-Nominal Drive Power: 50 watts
-AMP Input VSWR: 1.2:1 max.
-Output VSWR: 2:1 (typical)
-Output Power (@ +/- 1dB): 700 watts (PEP) SSB over 600 watts KEY DOWN
- SSB-CW : do not exceed the output power level of 600-650 watts;
- RTTY : do not exceed the output power level of 350-400 watts;
- AM : do not exceed the output power level of 125-150 watts.
-Output Filter: Low pass type
-Output Filter Band: 160 – 80 – 40 – 30/20 – 17/15 – 12/10 – 6 meter
-Harmonics: Better than –55dB
-Third Order IMD: Better than –32dB
-IN/OUT Impedance: 50 ohms unbalanced SO-239 connectors
-ALC: Adjustable negative going level –5VDC (10Kohms)
-PA Transistor: VRF151 MICROSEMI RF Power Vertical Mosfet
-Amplifier Circuitry: Push pull AB class
-Cooling: Quiet variable speed forced air cooling by built-in dual ball bearing fan
-RX/TX Switching Time: Lower than 10ms
-Switching Power Supply Protections: Short circuit, overload, over voltage, over temperature, bias stability
-RF Protections: High antenna VSWR (over 2:1), wrong band, input overdrive, over temperature,
bias stability
-AC Power Supply Range: 90 VAC to 260 VAC 50/60Hz
-Power Rating (max.): 1500 VA
-Power Line Fuse: 2 x 10 A (5x20 fast type)
-Color: Black / Silver-grey
-Dimensions (approx.): 37 x 32 x 17cm - 14,6 x 12,6 x 6,7 in. (L x D x H)
-Weight (approx.): 11 Kg (24,25 lb.)
To Next Page
Loading...