To Next PageTo Next Page
Need help?Do you have a question about the RGL KP1000 and is the answer not in the manual?
Details features like code entry, backlit keys, user codes, and metal case construction for the full range.
Highlights built-in proximity reader and dual open door modes for specific models.
Mentions Weigand terminals for connecting an external proximity reader.
Specifies 12VDC regulated supply with battery backup and recommended usage.
Details NO/COM/NC 3A relay for electric locks, advising wiring into this relay.
States Relay 2 is the same as Relay 1.
Lists standby and maximum current draw, excluding attached devices.
Describes normally open (N/O) contacts that close when pressed.
Specifies connection for an external bell/buzzer requiring 12VDC@100mA max.
Provides dimensions and read range for the built-in reader.
Lists compatible card types, specifically 26-bit EM cards.
Details operating temperature range and IP rating for external use.
Provides physical dimensions and weight of the unit.
Default engineer code is 1234.
Default open code for Relay 1 is 2580.
Default AUX code for Relay 2 is 0852.
Default open time for Relays 1 & 2 is 5 seconds.
Procedure to erase all memory and restore factory defaults, requiring engineer code.
Steps to recover or reset the engineer code if lost or corrupted, involving wiring and specific button presses.
Guide to changing the default user code for opening the door.
Instructions for adjusting the time delay for Relay 1 operation.
Steps to change the default engineer code for security reasons.
Guide to enrolling new 4-digit user codes, specifying position and PIN.
Procedure for removing an existing user code by its position number.
Steps to change the auxiliary code for Relay 2 operation.
Instructions for adjusting the time delay for the auxiliary relay (Relay 2).
Assigning user code positions to specific relays (Lock and AUX).
How to configure keypad backlight behavior, including permanent on/off or on-press.
Guide to enrolling EM type proximity cards, assigning them to user positions.
Procedure to delete an EM card when the card is present.
Procedure to delete an EM card using its user position when the card is not present.
Instructions for using a user code to open the door via Relay 1.
Instructions for using a user code to activate Relay 2.
How to use a proximity tag with the keypad to open the door.
General| User Codes | 1000 |
|---|---|
| Type | Standalone Keypad |
| Backlight | Yes |
| Operating Voltage | 12V DC |
| Interface | Wiegand 26 |
| Weight | 150g |
