2
WALL
STUD
MIRROR
FRAME
MIRROR
BRACKET
HANGMAN BRACKET
SCREW
NOGGINS
STUDS
STUDS
THADDEUS MIRROR 36" (91CM) X 48" (122CM) ENGLISH
REVISION 03-31-2023 RH.COM
WARNING
1. These mirror parts can be cumbersome to some people, therefore
the assistance of two or more people is recommended to prevent
personal injury and ensure the mirror is not damaged during the
assembly process.
2. Serious injury or death can occur if the mirror is not hung correctly.
Do not use wire to hang. Please follow the correct hanging
methods for the wall type. Consult a professional before hanging.
HERE ARE SOME GUIDELINES AS FOLLOW
1. If the wall is CONCRETE/MASONRY, drill a hole on each mark and
then insert a plastic wall anchor on each hole. Use a screwdriver to
attach the bracket to the wall.
2. If the mirror wall bracket will be installed on DRYWALL ALONG
WITH THE STUDS use a screw to fasten the wall bracket.
3. If the mirror wall bracket will be installed only on the DRYWALL, use
hollow wall anchors to fasten the bracket.
ASSEMBLY INSTRUCTIONS
1. According to your preference, you can conveniently install this
mirror in a landscape or portrait position. Pre-set the mirror on your
desired location and mark the location with a light pencil mark. Use
tape or pencil to transcribe the location of the wall into the mirror
bracket.
2. Hold the bracket against the wall and check the alignment of both
ends of the bracket that has the same distance on the floor or
ceiling surface.
3. After checking the level, fasten the brackets against the wall with
screws provided in your hardware packed. Please see FIGURE 01.
4. Install the mirror on the wall bracket as illustrated in FIGURE 02.
DRY WALL WITH STUDS
Screw inserted directly into stud
CONCRETE/MASONRY
DRYWALL WITHOUT AVAILABLE
WOOD STUD
Plug with wall anchor
FIGURE 01
FIGURE 02
To Next Page
Loading...
