To Next PageTo Next Page
Need help?Do you have a question about the Rheem A18AZ Series and is the answer not in the manual?
General| Series | A18AZ |
|---|---|
| SEER Rating | Up to 18 SEER |
| Refrigerant | R-410A |
| Phase | 1 |
| Dimensions (Outdoor Unit) | Varies by model |
| Weight (Outdoor Unit) | Varies by model |
| Type | Air Conditioner |
| Cooling Capacity | 18, 000 BTU/H - 60, 000 BTU/H |
| Operating Voltage | 208-230V |
Crucial safety warnings for installation and operation procedures.
Precautions to prevent equipment damage or personal injury.
Overview of the heat pump system and its operational capabilities.
Emphasizes quality installation for safety, reliability, and customer satisfaction.
Guidelines for selecting appropriate equipment for optimal system performance.
Explanation of model numbers and available unit configurations.
Detailed electrical and physical specifications including ratings and dimensions.
Lists required tools and specifications for R-410A refrigerant.
Specifies required clearances around the unit for optimal operation.
Details various methods for securely mounting the outdoor unit.
Factors and considerations for selecting appropriate refrigerant line sets.
Key practices and procedures for installing refrigerant tubing.
Steps for performing initial leak testing on the installed system.
Process for evacuating the system to remove air and moisture.
Final steps for leak detection after system evacuation.
Instructions for connecting control wiring for system operation.
Requirements and procedures for connecting power wiring.
Warning about the importance of permanent grounding.
Overview of the system start-up procedures for optimal performance.
Steps for initial power-up and verifying EcoNet™ communication.
Guide for setting up the EcoNet™ Control Center.
Procedure for entering charge mode via the EcoNet™ Control Center.
Procedure to verify and adjust indoor air-flow for proper system operation.
Procedures for checking and adjusting refrigerant charge.
Detailed description of system operation in cooling mode.
Detailed description of system operation in heating mode.
Explanation of the demand defrost cycle operation.
System operation when controlled by a conventional thermostat.
Description of the Universal Outdoor Control (UODC) unit.
How the power inverter controls compressor speed and operation.
Protection against excessively high discharge temperatures.
Protection against excessively high discharge pressure.
Protection against low suction pressure or loss of charge.
Sequence for compressor shutdown due to pressure faults.
Protection against voltage fluctuations affecting operation.
Protection against the inverter overheating.
Procedure to exit protection lock-out modes.
How to check transducers and temperature sensors for accuracy.
General guide for troubleshooting system problems and symptoms.
Charts for analyzing service issues and possible causes.
Tips for troubleshooting common system issues.
Procedure for cleaning the outdoor coil to maintain efficiency.
Recommendations for cabinet cleaning and protection.
Instructions for performance audit testing procedures.
