To Next PageTo Next Page
Need help?Do you have a question about the Rheem M5350ti and is the answer not in the manual?
General| Brand | Rheem |
|---|---|
| Model | M5350ti |
| Category | Swimming Pool Heater |
| Language | English |
Defines DANGER, WARNING, CAUTION, and NOTE for understanding safety alerts in the manual.
Covers water temperature limits, alcohol use, pregnancy, and chemical handling to prevent injury and damage.
Highlights the use of R-410A refrigerant and the need for specialized service equipment.
Details required spacing for air intake, service access, and discharge, avoiding obstructions and enclosed areas.
Specifies mounting on a level base, using isolation pads, and keeping it above standing water.
Explains the function of safety controls, selectors, and indicator lamps on analog models.
Details digital controls, safety features, and compatibility with external systems for pool/spa heating.
Step-by-step guide to start the unit using digital controls, verifying power and pump operation.
Guides on selecting pool/spa modes, adjusting temperature, and changing units (°C/°F).
Procedures for initial system start-up, seasonal checks, and maintenance.
Instructions for summer shutdown, freeze protection, and system drain-down.
Discusses operating the pump continuously for freeze prevention and its cost implications.
Procedures for cleaning the air coil and maintaining the unit's cabinet.
Instructions for checking and clearing condensation drain holes to prevent water issues.
Diagnoses common issues when the unit runs but fails to heat the water.
Troubleshooting steps for when the unit completely fails to operate.
How to identify and address excessive condensation, distinguishing it from leaks.
Guidance on verifying issues before calling for service and contact information.
Checking electrical power and water flow as common troubleshooting steps.
Instructions on setting the time clock for optimal unit operation cycles.
Electrical schematic for single-phase analog models, showing component connections.
Electrical schematic for single-phase digital models, detailing wiring for controls and components.
Electrical schematic for three-phase analog models, illustrating system wiring and connections.
Electrical schematic for three-phase digital models, showing wiring for digital control systems.
Specific wiring diagram for the Model 6350HC unit, detailing its electrical configuration.
Instructions for wiring and setting up a remote control for analog heater models.
Instructions for wiring and setting up a remote control for digital heater models.
