6
18.13" (46 cm)
7.91" (20 cm)
13.59"
(34.5 cm)
A
B
1.88"
(4.78 cm)
4.38" (11.13 cm)
4" FLUE
COLLAR
Figure 2. Dimensions
5. INSTALLATION
1. Start off by disconnecting main power to the heater.
2. Remove the front door from the heater. See Figure 3.
Figure 3. Door Removal
3. If this is a retro-fit application, remove existing
“Pagoda Top” and discard. See Figure 4. If equipped
with a drafthood, refer to drafthood installation
manual for removal process.
Figure 4. Pagoda Top Location
4. Remove the (6) Phillips screws that hold the jacket
top to the heater. See Figure 5.
(3) ON OTHER
SIDE
Figure 5. Screw Locations
5. Lift the rear end of the jacket top while inserting the
collar adapter. See Figure 6 and Figure 7.
APPROVED
UNCONTROLLED DOCUMENT IF PRINTED
To Next Page
Loading...