To Next PageTo Next Page
Need help?Do you have a question about the Rheem RHLL-HM3617JA and is the answer not in the manual?
General| Brand | Rheem |
|---|---|
| Model | RHLL-HM3617JA |
| Category | Air Handlers |
| Language | English |
Warning about disconnecting all power before installation or servicing to prevent severe injury or death.
Ensuring all disconnect switches are de-energized and locked before removing blower assembly.
Installation, service, and maintenance should be performed by qualified personnel; consumer service limited to filter.
Duct leaks can draw pollutants into living spaces, causing property damage, injury, or death.
Required use of RXHB combustible floor base for downflow on combustible flooring to prevent fire.
Unit must be permanently grounded to prevent electrical shock and potential death.
Line side of circuit breaker is energized even when de-energized; contact can cause shock.
Do not connect return ductwork to other heat-producing devices to prevent fire, CO poisoning, or explosion.
Use only specified screws for motor shell mounting to avoid contacting motor winding.
Do not operate without filters; dust can lodge in ducts and soil surfaces.
First 36 inches of supply air plenum/ductwork must be sheet metal; avoid exposing combustible materials.
Warning about CO poisoning from fuel-burning devices and vehicle exhaust drawn into living spaces.
Importance of duct system balance and sealing for efficiency, comfort, and indoor air quality.
Details requirements for branch circuits, disconnects, conductors, and connection points.
Specifies low voltage control wire requirements and separation from power wiring.
Mandates permanent grounding of the unit for electrical shock prevention.
Detailed electrical data for HSL models with electric heat, including kW, circuit amps, and protection.
Detailed electrical data for HLL models with electric heat, including kW, circuit amps, and protection.
Table of operating limits for cooling and electric heating based on cabinet size and CFM.
A checklist of essential steps to verify before starting the unit for the first time.
Step-by-step instructions for removing and replacing the blower assembly.
