Your Rhino Security system incorporates the latest in high security & convenience features.
It is possible to customise your security system so that it suits your requirements perfectly.
Detailed below is the full list of programmable features that can either be turned on or
turned off.
We have set at the factory, the most common configuration chosen and these settings are
listed in the REGISTER Settings listed below. Once the desired features have been selected,
the selection is permanently retained in memory, even if power is removed.
To turn on or turn off any feature use the following procedure: eg to enable silent arming.
1. Arm then disarm the alarm system.
2. Within 20 seconds of disarming, turn the ignition key to on.
3. Immediately after turning the ignition on, press the remote control button an equal
number of times to the selected feature’s code no. (eg 14 times for silent arming).
Leave a 2 sec. gap between each press.
4. Now turn the ignition to off.
5. The system will now confirm whether the feature has been turned on or off via visual
readout. One flash of the indicators means the feature is on. Two flashes means the
feature has been turned off.
PROGRAMMABLE
FEATURE
Press
Remote
This Many
Times
INITIAL
FACTORY
SETTING
DESCRIPTION
Voltage Drop (Current)
Sensing
8 ON If deactivated, this feature will prevent the
alarm triggering via sensing a drop in voltage in
the vehicle’s electrical system. This may be
necessary where engine thermo fans cut in
automatically or there are other accessories
active even when the ignition is turned off eg
fridges, car phones.
Auto Re-arm 10 ON If system is disarmed and a door is not opened,
or the ignition turned on within 30 seconds, the
system will rearm & relock. (where central
locking is connected)
Central Closure 12 OFF When on, the lock & unlock outputs become a
5 second negative pulse instead of 0.8
seconds. This feature is for certain vehicles
with vacuum central locking or those with a
central closure wire (some BMW, Mercedes) ie
doors lock, electric windows wind up, sunroof
closes automatically.
Silent Operation 14 OFF This feature when turned on, stops the siren
from beeping for arm & disarm confirmation,
and the siren from sounding on alarm trigger
i.e. only the blinkers will flash.
3
To Next Page
Loading...