RHINO RVS950 - Warning; Safety Information

2
IMPORTANT
WARNING/ SAFETY INFORMATION
This product must only be used in vehicles fitted with a cargo barrier
Compliant to: AS/NZS4034:2008
- Before installing the RVS950, the user must check the vehicles load capacity with the - Before installing the RVS950, the user must check the vehicles load capacity with the
manufacturer of their vehicle. Ensure the vehicle is capable of supporting the maximum load manufacturer of their vehicle. Ensure the vehicle is capable of supporting the maximum load
of the RVS950. of the RVS950.
- The load on each shelf must not exceed 30kg and must be evenly distributed across the shelf.
- The total combined load of the RVS950 must not exceed - The total combined load of the RVS950 must not exceed 120kg120kg. .
- The user must adhere to the payload limits of their vehicle.- The user must adhere to the payload limits of their vehicle.
- The RVS950 must be installed in accordance with the instructions using only the hardware - The RVS950 must be installed in accordance with the instructions using only the hardware
supplied. Failure to follow the instructions correctly may result in serious injury or death. supplied. Failure to follow the instructions correctly may result in serious injury or death.
- The RVS950 must not be modified in any way and must be maintained in good working order.- The RVS950 must not be modified in any way and must be maintained in good working order.
- Loads shall be secured to achieve the requirements of the Load Restraint Guide, 2018 as issued by - Loads shall be secured to achieve the requirements of the Load Restraint Guide, 2018 as issued by
National Transport Commission. National Transport Commission.
- The RVS950 must undergo minimum annual inspection by a competent person to ensure
suitability for continued safe service. Any indication of critical flaws or risks to continued
service (damage, wear, corrosion…) shall be further investigated and made good before
returning to service.
- The handling characteristics of a vehicle will change when the RVS950 is fitted and
especially when it is loaded (in particular, handing on bends, and braking). Driving techniques
should be altered to allow for these changes, reducing speed, especially on bends, and allowing
for longer braking distances.