RHYNO Caravan Mover User Manual

Fitting instructions
The Rhyno unit is designed to t in a
simple but secure way to your caravan.
Tools required:
17mm socket or ring spanner
Standard screwdriver
Phillips screwdriver
Wire cutters
A power drill
22mm spade drill
Scissor car jack or trolley jack
Matt or ground covers for lying on
The rst step to successfully tting
your Rhyno Caravan Mover is to ensure
that all the components are laid out
together and to check that all the
following parts are included:
8 x M10 nyloc nuts
8 x M10 X80 high tensile bolts
8 x self-tapping screws
1 x control module
1 x handset
1 x aux cable
2 x bottom plates
2 x middle plates
2 x top plates
1 x red lead short
1 x red lead long
1 x black lead long
1 x isolator switch with key
12 x cable ties
2 x shear bolts
1 x cable grommet
Prepare your caravan. Ensure there
is sufcient ground clearance and the
front of the caravan is raised to allow
you to have access to the underneath
of the caravan.
Apply the hand brake and have at least
two legs lowered whilst working under
the caravan.
Remove all security wheel clamps.
Clear the bunk or cupboard at the
rear of your battery box ready for the
positioning of the electric control box.
Mount one of the motor units onto the
jack or wooden blocks and raise into
position as shown below.

RHYNO Caravan Mover Specifications

General

Type	Caravan Mover
Voltage	12V
Soft Start	Yes
Remote Control	Yes
Automatic Stop	Yes
Installation	DIY or Professional
Control	Remote Control

Summary

Fitting Instructions

Tools and Parts Checklist

Lists essential tools for installation and components to verify before fitting.

Caravan Preparation Steps

Guidance on preparing the caravan, including ground clearance and securing.

Motor Unit Installation and Alignment

Instructions for mounting motor units, aligning them with wheels, and setting clearances.

Control Wiring and Electric Box Connection

Details on feeding control wires and connecting the main electric control box.

Handset Tuning Procedure

Steps to tune the remote handset to the mover's control box.

Power Connection and Switch Installation

Procedure for connecting power to the control box and installing the main on/off switch.

Final Cable Management and Checks

Guidance on managing excess wiring and securing the system before use.

Warranty Details

Covered Components and Periods

Details on what parts are covered by the warranty and for how long.

Warranty Exclusions and Limitations

Lists conditions and damages that are not covered by the warranty.

Claim Process and Support

Instructions on how to make a warranty claim and obtain support.