RELEASE
SAFETY
2° Installing and adjusting the limit switch cams
Position the cams at the ends of the rack rail.
Tighten the two screws to secure them in place.
Open the shutter door of the K400.
Insert the key and turn in a clockwise direction.
Pull the lever to unlock the operating system.
Check the cam intervention point by opening and closing the gate.
N.B.: The cams should press the electric micro-switches before the moving part
touches the mechanical stops (K400 FCE). The DL7 and DL8 LEDs switch o
when the cams are detected by the proximity sensor (K400 FCM).
Position the gate halfway and re-secure the operating system.
ITA ESP ENG FRA GRE DEU RUS ARA THAI BUL FAR TUR HIN CHI POL HUN CEK KOR
To Next Page
General
